Inset Taxiway Edge | ZA292

• Body casting manufactured from aluminium alloy for lightness, strength and durability
• IEC body style as standard, PSA 8” 2 hole and 8” 3 hole versions available
• 3 hole body option for direct installation to SRA8/13 adaptor ring
• Long life lamps (objective life of 1500 hours at full brilliancy)
• Prism removal and replacement achieved without the need for adhesive or sealants
• Colour beam variations achieved by dichroic coated or coloured glass
• Lamp by-pass options available if required
• Suitable for direct installation in a ZM109, ZM181 PSA or ZM203 IEC seating pot with only two point fixing
• Pre-focused optics to simplify maintenance procedures
• Low profile (10mm)
• Commonality of parts with the ZA181 and ZA280 inset fittings
• Light channel within 5mm of Grade
• Natural anodised finish (as standard), powder coated NATO green or golden yellow (Special Order)
• IMM available on request

Omni-directional inset fitting for Taxiway, Helipad, LI Runway Edge and general applications.

• ZM109 8” seating pot (wet) – PSA 2/3 Hole
• ZM181 8” seating pot (dry) – PSA 2 Hole
• ZM203 (I) seating pot (dry) – IEC • ZM203 (I) seating pot (wet) – IEC
• 12” and 15.5” PSA & FAA L868 cannister adaptors
• ZS023 sighting device
• ZM109, ZM181, ZM203(I) installation jigs

Electrical supply Suitable for use in 6.6A airfield lighting circuits normally supplied from 1 x 45W, 65W or 100W isolating transformer. 120V and 240V mains supply versions also available. Power consumption is either 30W, 36W, 40W, 49W or 105W depending upon type of lamp fitted.